ACER ASPIRE ONE NAV50 VIDEO DRIVER HOW TO

Here's the teeth of a hub flange I needed to replaced (~$50 each). I've replaced or even swapped hub flange of PS with DS to help tight up the back lash of hub flange to axle teeth. I do wipe off excess, without using a degreasing during assemble. I've gotten more and more liberal with marine grease over the years. This stop corrosion, makes for better seal, easy removable and cleaning next servicing as it protects. I put a thin layer of grease on all contact points included those of gasket, or any exposed metal. So I can then inspect & clean out and then grease with marine grease, leaving drain hole at bottom open and clean. I also like removing the knuckle dust cover if corroded in speed sensor area or my first service of a rig.

ACER ASPIRE ONE NAV50 VIDEO DRIVER HOW TO

How to lubricate front axle shaft bushings? There are easy fast ways to grease the axle bushing & bearings without removing knuckle: Here's a look at back side of knuckle, where axle bushing and needle bearings are located: The road vibration and wondering was really bad, and made it unsafe to drive, now it's drives smooth and safe as new. On this rig pictured below, the loose wheel bearing damage was exuberated by not balancing tires regularly/properly and worn steering rack bushing. If not corrected the damage will extend too other parts. This chatter then starts wearing on all components widening snap ring gap and wearing teeth of hub flange and axle. Loose wheel bearings cause chatter which is evidenced on claw washer scoring. On this bearing service job, I found damage on outboard front drive shaft dust cover seals, hub flange teeth and excessive snap ring gaps of 0.60mm during disassemble.

I've seen from 23ft-lbf to 63tf-lbf torque just to get 9.5 - 15lbf on breakaway preload using a fish scale on used bearings (100k to 200k miles). I've found the older the bearing, the higher the torque needed to get the proper breakaway preload. I really wouldn't do a wheel bearing service without a pull (fish) scale, or it is just guessing. I've not yet had a problem with bearings being too tight, but have seen many issue when loose. I'd flip claw washer so smoothest side in or replace with new. How much torque did you use on adjusting nut?Д®ach lock washer tabs can only be safely bent once. What grease used for axle bushing & needle bearing? How'd bearings & races look after cleaning?

Acer aspire one nav50 video driver